Testing the ignition control module (ICM), which is located inside the distributor on the 1999, 2000, or 2001 2.0L Honda CR-V, is not that hard to do.
In this tutorial, I'll explain how to test it. With the results from the ICM test, you'll be able to find out if it's defective or not.
I'm also going to show you where you can buy the ignition module and hopefully save a few bucks..
Contents of this tutorial at a glance:
Download the free ignition control module troubleshooting guide PDF here: Ignition Control Module Troubleshooting Guide.
See the youtube video of this tutorial here: How To Test The Ignition Control Module (1999, 2000, 2001 2.0L Honda CR-V).
You can find this tutorial in Spanish here: Cómo Probar El Módulo De Encendido (1999-2001 2.0L Honda CR-V) (at: autotecnico-online.com).
The following tutorials may come in handy:
- How To Test The Ignition Coil (1999-2001 2.0L Honda CR-V).
- How To Test The Ignition Control Module (1997-1998 2.0L Honda CR-V).
Test The Ignition Coil First
Before you start your ignition control module diagnostic, you first need to test the ignition coil.
The idea behind testing the ignition coil first, is to make sure that it is NOT defective and thus NOT behind the no-start condition of your 1999-2001 2.0L Honda CR-V.
I can tell you from personal experience, that the ignition coil test is not hard. I have written a tutorial that will show you how to test it in a step-by-step manner. You can find this tutorial here: How To Test The Ignition Coil (1999-2001 2.0L Honda CR-V).
Where To Buy The Ignition Control Module
The 2.0L Honda CR-V ignition control module is one expensive bad boy. Check out the following links and comparison shop:
Distributor Connector Circuit Descriptions
The distributor on the 1999, 2000, and 2001 2.0L Honda CR-V has 8 wires coming out of its connector.
To be able to test the ignition control module, we need to know which wires are the one ones that provide battery power and the ICM control signal. So, in the table below, you'll find a brief description of all 8 wires:
| 1999-2001 2.0L Honda CR-V Distributor Connector | ||
|---|---|---|
| Pin | Wire Color | Description |
| 1 | YEL/GRN | ICM Control Signal |
| 2 | BLU | CKP Sensor |
| 3 | GRN | TDC Sensor |
| 4 | YEL | CYP Sensor |
| 5 | BLK/YEL | Power (+) |
| 6 | WHT | CKP Sensor |
| 7 | RED | TDC Sensor |
| 8 | BLK | CYP Sensor |
It's important to note that the connector on the distributor itself has male spade terminals.
The engine wiring harness distributor connector has female terminals. Avoid inserting your multimeter test probes inside the female terminals (of the distributor engine wiring harness connector) to avoid damaging them.
NOTE: You can find the ignition system wiring diagram (1999, 2000, and 2001 2.0L Honda CR-V) here: 1999-2001 2.0L Honda CR-V Ignition System Wiring Diagram.