How To Test The Fuel Pump (1995-1997 3.0L V6 Ford Ranger)

Using Starting Fluid

How To Test The Fuel Pump With Starting Fluid (1995, 1996, 1997 3.0L Ford Ranger And Mazda B3000)

One of the quickest ways to find out if lack of fuel is causing the engine not to start is a starting fluid test.

The starting fluid is sprayed into the throttle body bore, and then the engine is cranked.

If the engine starts and runs, you can conclude that the engine is probably not getting fuel from the fuel pump.

I would like to emphasize that the starting fluid test is not the most accurate method of checking the fuel pump. When I perform this test, I still do a fuel pump pressure test with a fuel pressure gauge.

IMPORTANT: The accuracy of the starting fluid test depends on all six spark plugs delivering spark to their cylinders. If you haven't checked the spark plug wires for spark (using a spark tester), do so before beginning the test. Otherwise, you may get a false positive result with this test.

These are the test steps:

  1. 1

    Remove the intake air duct from the throttle body.

    You don't have to completely remove it, since you'll have to reconnect it in one of the next steps.

  2. 2

    Open the throttle manually, and spray starting fluid down the bore.

    When you have sprayed a good squirt of starting fluid, quickly reconnect the air duct to the throttle body (you don't have to tighten the hose clamp).

    Reconnecting the intake air duct is a very important safety precaution in case you get a back-fire thru' the intake manifold.

  3. 3

    Crank the engine once the intake air duct is back on the throttle body.

  4. 4

    You'll get one of two results:

    1.) The engine will start momentarily and after a few seconds will die.

    2.) The engine will only crank but not start at all.

OK, let's analyze your test result:

CASE 1: The engine started and ran for a few seconds. This result confirms that the engine no-start problem is caused by a lack of fuel.

Next, I suggest that you test the fuel pump fuel pressure with a tester. For this test go to: Using A Fuel Pump Pressure Tester To Test the Fuel Pump.

CASE 2: The engine DID NOT start, even briefly. This result generally tells you that a lack of fuel is NOT the reason the engine won't start.

Remember what I said about this test not being very accurate? Well, I suggest you do one more test and test the fuel pressure with a fuel pressure tester. For this test go to: Using A Fuel Pump Pressure Tester To Test the Fuel Pump.

More 3.0L Ford Ranger Tutorials

You can find a complete list of tutorials here:

Here's a sample of the tutorials you'll find there:

Thank You For Your Donation

If this info saved the day, buy me a beer!

If This Info Saved the Day, Buy Me a Beer!

Ford Vehicles:

  • Ranger 3.0L V6
    • 1995, 1996, 1997

Mazda Vehicles:

  • B3000 3.0L V6
    • 1995, 1996, 1997